A front wall is a level joint in which a ceiling meets a wall. This illustration shows the appropriate flashing in a front wall condition. The front wall flashing should extend up behind the outer wall cladding and down over the roofing material, as you can see here. Think of beams as the skeletal system of your roof.
The beams are designed as a sloped structural unit that mainly uses 2x10s or 2x12s and extend from the ridge of your house to the wall plate. It is fixed right at the point where the edge of the roof meets the siding of your house. The roof fascia is a series of wooden planks that give structure to the sides of your house. Without the fascia, your gutters and downspouts wouldn't have as much support and would simply hang on one side of your house.
They hang from the side of the roof (under the fascia) and provide additional protection against the elements for the rafters. Shelving: method of installing shingles straight up from the roof. Houses should have a flashing piece of metal where the roof meets the siding. This is called a stepped flashing and lies flat on the roof at an edge, usually under shingles.
The other edge goes behind the coating. A neck flange, sometimes called a collar beam, runs parallel to the roof joists, but higher. Each neck tie connects a pair of matching beams in the middle of the span, reinforcing the beams and strengthening the overall structure. Above rooms with vaulted or raised ceilings, collar flanges sometimes bend like ceiling beams, providing the essential bottom chord of the triangle, and can also provide a backrest for attaching a flat portion of the ceiling.
Downspout: A pipe that attaches to the sides of your house and directs water from roof gutters away from your home. Because this collects water runoff from two roofing planes, it is generally protected by metal valley flashings. Valleys: Area where two adjacent sloping roof planes intersect on a roof, creating a “V” shaped trough. The bottom “rope” of the triangle, the roof truss system prevents the walls of the house from separating under significant roof loads that push down and out.
Penetrations: Anything that passes through the roof surface, such as chimneys, vents, or pipes. Drip Edge An L-shaped metal strip placed along the edges of the roof to allow water to drain down the roof without running down the eaves or siding. The soffit is the horizontal bottom of a roof eave, arch, staircase, roof, or similar architectural component. Overdriven: A term used for fasteners that go through the roofing material too hard, breaking the material.
Attic - structure protruding from the plane of the roof slope, often with the addition of windows. In the 17th and 18th centuries, the “ridge piece” and “ridge post” were used respectively to designate a horizontal timber or a post on the ridge of a roof. Whether you're preparing to replace the roof or schedule a roof inspection, don't hesitate to talk to your local roofing contractor to learn more about your roofing system. Benefits of installing skylights on the roof include better ventilation, more natural sunlight, and more natural views.
If your home has vinyl siding and ceiling tiles, chances are you have a fascia cover that is often called fascia metal and is usually made of aluminum trim with a wood grain texture and a colored PVC siding. Beam tails: A gable roof is framed with beams that run diagonally from the roof ridge to the eaves. As you can see in the following illustration, the roofs have hip beams, ridge boards, cat beams and more. .
